ACCESSORIES & EXTRAS

For use with Dance Floors

BASEBOARD MOLDING
RAMPS
SLIP NO MORE
The Gerstung Vented Baseboard covers the ½” (13mm) expansion gap along the wall. The wooden baseboard, with its 1/8” (3.2mm) flutes on the back, allows the compressed air below the floor to constantly escape. The baseboard is custom finished to complement the top surface and must be ordered separately.
Ramps are necessary if Airbase® floor is installed in a room without a depressed foundation. To eliminate the need for ramps we can supply dimensions for a floor depression. Our standard ramp measures 8” (20.3cm) in width. For ADA access, we can provide a ramp with a 1:12 slope. Please check with our design department for proper site preparation regarding entrances and exits.
"Liquid Rosin." A non-slip solution that adds slip-resistance to all floors including wood, tile, vinyl and linoleum. To be used on any surface you can apply water to. No More Rosin Mess! Will not damage any surface. You control the degree of non-slip simply by adding water. Ideal for performances, on tour, or for slippery studio floors. Available in gallon containers (3.78 lt.).

SEAMING TAPES:
DOUBLE FACED TAPE
CLOTH TAPE
VINYL TAPE
Primarily used for adhering Flex Tread, Tuff Tred, Pad-N-Carpet, or Vinyl to a sub-floor. This is a very strong, near permanent instillation product. You may find other uses for it . . . like hanging plaques on the office wall. 75’ (23m) rolls, 2” (5cm) wide.
For seaming vinyl on a temporary or semi-permanent instillation. 180” (55m) rolls, 2” (5cm) wide. Popularly known as “gaffer’s tape”; very durable. (black or gray)
Seaming tape for vinyl, especially for temporary use. 108’ (33m) rolls, 1 ½” (38mm) wide. Less expensive & less permanent than cloth. Recommended for use with Dance Vinyl. (gray)

DANCE FLOORS

Vinyl Surfaces

Hardwood Surfaces

AirBaseŽ Subfloors
---What is an AirBaseŽ ?

Accessories

Technical Specifications
Partial Client List

Ordering & Information